FFConfigLite

Diagnose and configure modules in your Ford Focus 2 or C-Max I using an ELM327 or ELS27 interface. These tools provide access to various CAN-bus modules:

Engine Control Module (ECM): Access module information, read and clear diagnostic trouble codes (DTCs), reboot the module, and reset the long-term fuel trim (KAM) for the following engines: ESU-411/418 (1.8 125/2.0 145), SIM28/29 (1.4 80/1.6 100/115), and ESU-121/131 (1.8 120/2.0 145).

Instrument Cluster (Dashboard): Access module information, read and clear DTCs, configure the module, reboot the module, change the odometer reading, and correct the mileage. *Note: Some features may require the full version of the software.*

Brake Control Module (BCM): Access module information, read and clear DTCs, configure the module, reboot the module, reset the Dynamic Stability System (DDS) calibration, and perform brake bleeding. *Note: Some features may require the full version of the software.*

Body Control Module (BCM): Access module information, read and clear DTCs, configure the module, and reboot the module. *Note: Some features may require the full version of the software.*

Supplemental Restraint System (SRS) Module (Safety Module): Access module information, read and clear DTCs, configure the module, reboot the module, and clear crash data. *Note: Some features may require the full version of the software.*

Transmission Control Module (TCM): Access module information, read and clear DTCs, and reset the KAM. *Note: Some features may require the full version of the software.*

Climate Control Module (CCM): Access module information, read and clear DTCs.

Audio Control Module: Access module information, read and clear DTCs, and retrieve the radio code (for M-series radios). *Note: Some features may require the full version of the software.*

For full application functionality and access to additional modules, a minor modification to the ELM327 adapter may be necessary. Instructions can be found here: Http://forffclub.narod.ru/index/0-2

ELS27 adapters can be purchased at: https://els27.ru/. For ELS27USB, set the baud rate to 38400; for ELS27BT, set it to 2,000,000 using the ELS27 Baudrate utility.